EVA Vacuum Glass Laminating Machine Operation (1)

EVA Vacuum Glass Laminating Machine Operation

①Machine operation:

1. prepare the glasses, first use edging machine edgeing the glasses.

2 same size glass, pay attention to the four corners, it must be edging like round arc, to avoid breaking the silicone vacuum bag, wash the glass with washing machine, it must be air-dry, this is very important.

3.Cutting Eva film, cut the EVA film a little larger than the two glasses.

3.lie down one glass, put EVA film onto it, and also put the color materials, then put another glass onto it, cut out the rest EVA film and color materials, stick the 4 corners then.

EVA Vacuum Glass Laminating Machine Operation
EVA Vacuum Glass Laminating Machine Operation

All rights reserved by ★Silicone Vacuuming Bag /Sheet  for EVA Glass Laminating Machine / Solar EVA Photovoltaic Panel Encapsulations(uc@ucolin.com / www.ucolin.com /umewe360@gmail.com)

4. Put glass into the silicone vacuum bag, put the glass onto the vacuum iron table, you should leave 1cm distance between the glasses. After finishing this, connecting the vacuum pipe, as picture blow.

EVA Vacuum Glass Laminating Machine Operation
EVA Vacuum Glass Laminating Machine Operation

Start vacuum pump, first check the wire connecting of the vacuum pump right or wrong, then start the vacuum pump, when the vacuum indicator shows lower than -0.1MPA and become steady, close the door, and wait till to finish the whole process.

All rights reserved by ★Silicone Vacuuming Bag /Sheet  for EVA Glass Laminating Machine / Solar EVA Photovoltaic Panel Encapsulations(uc@ucolin.com / www.ucolin.com /umewe360@gmail.com)